1-Channel Relay Board | AC250V/DC30V@10A


  • Easily add a high-current relay module (AC250V 10A; DC30V 10A) to your project!
  • Status-indication LED is included on the board
  • Opto-isolated control input requires 15~20mA driving current
  • Connects directly to digital outputs of your favorite microcontroller board (Arduino, ESP8266, ARM) or single-board computer (Raspberry Pi, Beaglebone)



This 1-channel relay interface board allows you to control different appliances and equipment that use high-current draws using low voltage outputs such as those used by microcontrollers like Arduino (ATmegas, ARMs) and ESP8266 development boards, or by SoCs like the ones on a Raspberry Pi or BeagleBone single-board computer.

This module is very straight-forward to use, you connect the pin header to power (5V and Ground) and to the digital I/O of your microcontroller or SoC. Then, you use the screw terminals to connect the HOT/LIVE wires of your appliance and its supply. The supply wire goes into the COMMON terminal (located in the middle of each 3-pin terminal), and the HOT/LIVE wire goes into either the NO or the NC terminal located besides each the COMMON terminal. Depending on the logic level on the microcontroller/SoC side, the COMMON terminal is connected to either the NO or the NC terminal and can be switched back and forth by firmware/program’s logic.

Please remember to always use proper precautions when working with high-current devices!


  • 5.0×4.5cm breakout PCB for a high-current relay module!
  • Sturdy (1.6mm), blue PCB with a 4-pin header on one side (Vdd, Vss, IN1) and 2×3-pin screw terminals on the other (NO, COMMON and NC)

Additional information

Product Dimensions

0.98 x 1.77 x 0.79 inches

Item Weight

2 ounces



Item model number


Date First Available

April 3, 2017




There are no reviews yet.

Be the first to review “1-Channel Relay Board | AC250V/DC30V@10A”

Your email address will not be published. Required fields are marked *